Toothbrush Stand with Drip Tray

The Toothbrush Stand with Drip Tray is a toothbrush holder you print yourself, for four toothbrushes and a tube of toothpaste standing on its cap.

The difference from an ordinary cup: every slot drains through the bottom. Water does not collect in a puddle at the bottom of the slot but drips into a removable drip tray, which you lift off and rinse.

• Holder: 140 × 60 × 85 mm
• Drip tray: 144.4 × 64.4 × 12 mm
• 4 slots, 17 mm diameter and 82 mm deep
• Oval toothpaste slot, 36 × 48 mm
• Two parts, no supports, digitally checked for printability

Fits: manual toothbrushes with handles up to about 15 mm thick. Electric toothbrushes do not fit.

Print tips: PETG is recommended for the bathroom, as it handles moisture and heat better than PLA. The holder is a solid model; your slicer fills it with infill. 10 to 15% gyroid is enough. 0.2 mm layers, 3 walls. The holder sits in the tray with 0.2 mm clearance per side.

Rinse and dry the tray regularly. A printed surface has fine layer lines where grime can collect, so clean the holder now and then with warm water and a small brush. You get two STL files and one 3MF.