LED & electronics to print yourself
Cases for LED controllers, for a tidy and safe installation on the wall or in a cabinet.
3 of 3 designs
About LED & Electronics
This category has designs for your LED setup, such as cases for LED controllers that you mount on a wall or inside a cabinet. A loose controller with dangling wires looks messy and easily comes loose; a case that fits keeps everything tidy.
- Case that fits the Gledopto GL-C-015WL-D: for the ESP32 WLED controller with microphone, with holes for the buttons, a window for the status LED and room for a power plug.
- Case that fits the Gledopto GL-C-006P: for the Zigbee and RF controller for CCT strips, with tie-wrap eyelets for strain relief and a rail that clicks into place.
Each case has a wall plate, a base and a cover, with no metal parts, so WiFi, Zigbee and RF pass straight through. All designs print without supports, and every product lists the measured size of the controller.
Frequently asked questions
Are these official Gledopto products?
No. They are LayerKit's own designs that fit the controllers named. The brand name is only there to show which controller fits.
Which filament should I use for a controller case?
PETG is a good choice because it handles heat better than PLA. Indoors, away from direct sun or a heat source, PLA is fine too.
How do I mount the case?
Screw the wall plate on with 2 countersunk 3.5 mm screws or stick it with 2 strips of VHB tape. Then slide the base with the controller onto the rail from above and click the cover on.