Support-free
3MF + STL
Kitchen1 part
Hex Spoon Rest
Elongated hexagonal dish for next to the stove, with two troughs for ladles, spatulas or wooden spoons. The handle sits in a notch in the rim, so the spoon does not roll off and drips stay in the trough. Made for spoons, not for hot pans. Prints without supports.
- Size
- 168.1 × 118 × 16 mm
- Layer
- 0.2 mm
- Material
- PETG aanbevolen
€1.49incl. VAT
- 3MF
- STL
- Digitally checked for printability
- Prints without supports
- Download right after payment
- 3MF + STL in one ZIP
Digital product: STL and 3MF files, not a physical item. Pay with iDEAL, Bancontact, credit card or Apple Pay.
Colours in the photo
About this design
The Hex Spoon Rest is an elongated hexagonal dish for next to the stove. It holds two ladles, spatulas or wooden spoons, each in its own trough. The handle rests in a round notch in the rim, so the spoon does not roll off and drips stay in the trough instead of on your worktop.
- Size 168 × 118 × 16 mm
- Two troughs of 118 × 44 mm at the bottom, 13.6 mm deep with sloped walls
- 14 mm wide notches for the handles
- Prints without supports, digitally checked for printability
Print tips: print flat on its base, as supplied, with 0.2 mm layers, 3 walls and 20% infill. Use PETG: it copes better with a warm spoon straight from the pot than PLA, which softens above roughly 60 degrees. The spoon rest is made for spoons, not for hot pans or lids. Hand wash only.
You get one STL file and one 3MF.
Parts and dimensions
Dimensions w × d × h, each part checked separately.
-
spoon-rest-hex.3mf
- Dimensions (w × d × h)
- 168.1 × 118 × 16 mm
- File
- 12 kB
You get all files together in one ZIP.
- spoon-rest-hex.3mf12 kB
- spoon-rest-hex.stl44 kB
80 layers of 0.2 mm (spoon rest hex, 16 mm tall)
Print settings
- Layer height
- 0.2 mm
- Walls
- 3
- Infill
- 20%
- Supports
- Not needed
- Material
- PETG aanbevolen
Designer's tip
Print flat on its base as supplied. PETG copes better with a warm spoon straight from the pot than PLA; PLA softens above roughly 60 degrees. Do not put hot pans or lids on it. Hand wash only.
Frequently asked questions
Can I put a spoon straight from the pot on it?
Yes, if you print it in PETG. PLA softens above roughly 60 degrees. Do not put hot pans or lids on it.
Do large ladles fit?
Each trough is 44 mm wide at the bottom and flares to about 50 mm. Spoons and spatulas with a head up to about 50 mm wide sit well.
Is it dishwasher safe?
Better not. Wash it by hand in warm soapy water and it will look good for longest.
License at a glance
You may
- Print for yourself, your family and as a gift
- Sell printed copies in small quantities
You may not
- Resell or share the files
- Upload the files to other platforms
Read the full license For digital content, the right of withdrawal ends once you agree to immediate delivery at checkout. Right of withdrawal
